Project 5 Nut High

FAQ

What is the Project 5 Nut High?

The Project 5 Nut High is a metal insert nut used as a replacement and accessory part in the wing and foil area. It is designed to securely fasten and allow loosening of screw connections on the foil, board, or other components.

For what purposes is the Nut High suitable?

The nut is suitable for repairs and replacing lost or damaged insert nuts on your wing or foil setup. This allows you to reliably re-establish screw connections on the mast, fuselage, or board.

In what sizes is the Project 5 Nut High available?

The Project 5 Nut High is available in several sizes. Which version you need depends on the diameter of the corresponding screw – choose the size that matches your existing setup.

What should I pay attention to when choosing the right size?

Make sure that the inner diameter of the nut matches the thread diameter of your screw. If in doubt, measure the thread of your original screw or compare it directly with the previously installed nut.

How is the insert nut installed?

The nut is inserted into a suitable hole and recessed flush into the component using a suitable tool. The screw can then be screwed in and the connection established as usual.

What material is the Project 5 Nut High made of?

The Nut High is made of metal and is designed for use in water sports. It is robust against the typical stresses of wing foiling and foiling.

Can I also use the Nut High with other brands?

As long as the dimensions and thread match the screw and the existing hole, the nut can be used across brands. Check the dimensions of your setup.

Where can I buy the Project 5 Nut High?

You can get the Project 5 Nut High at Surfshop Fehmarn – with personal advice and fast shipping, so that you have the right replacement part on hand when needed.